Tremec has built a running manual-transmission C8 Corvette development car, offering a concrete look at the third pedal Chevrolet did not offer in the mid-engine sports car. The vehicle is a one-off Peitz Performance C8 race car, not a showroom model, and it was driven at Motorsports Gateway, a new private track outside Howell, Michigan, during a Tremec event attended by a driver and several potential customers.
The C8 was Chevrolet’s first mid-engine Corvette and its first with a dual-clutch automatic as the only transmission. After decades of front-engine development, Chevy faced the cost of developing two new transaxles, one manual and one automatic, for a mid-engine car. The reported reasoning is that GM chose the automatic rather than fund both, a decision that produced a capable Corvette but left some enthusiasts wanting a manual. Tremec, builder of the TR-6060 six-speed used in GM performance cars including the Blackwing models and the Camaro, developed the manual C8 car.
What the track car reveals
The test car is a track build with almost no interior finish. The shifter emerges where the C8 normally has a storage cubby and automatic gear selector, and the cabin has a full cage and harness. The seating position has virtually no adjustment, and the driver, at 5-foot-7, could not plant either foot on the floor, making heel-and-toe work awkward. Those limits kept the drive below the car’s limit, especially on a green track on a November afternoon in Michigan.
Mechanically, the conversion is less drastic than the stripped cabin suggests. Peitz had to cut the tunnel to install clutch-pedal hardware, but Tremec’s manual transaxle occupies the same place as the stock dual-clutch unit and needs no special mating hardware. The C8’s pedal box has enough room for a clutch, and the footwell felt roomier than a previous-generation Camaro’s even with the third pedal.
Remote shifter changes the feel
The transaxle’s shifter is remotely mounted, with a cable running back to the gearbox. That makes the mechanism less precise and less snick-snick than the front-engine TR-6060, and slightly less notchy. That trade-off may appeal to drivers who prefer smoother edges, while others may miss the more mechanical feel of the front-engine arrangement. Moving the engine forward would effectively return to a C7 layout; moving the shifter rearward would put the driver near the C8’s engine location.
Cost is the larger obstacle. Tremec says the gearbox alone costs about $75,000, and combined with the Corvette, a manual C8 build rivals a showroom-spec Z06. The company expects the price to fall as volume rises. Tremec says OEMs are interested, not necessarily or exclusively GM, and that other automakers want a high-torque manual transaxle; no customers were named. The gearbox was engineered to fit the C8, but the development car does not establish a production program.
