Zeph Gage has developed a rear-only portal axle for his Jeep XJ by flipping a Ford 9-inch differential upside down, a custom approach intended to deliver the clearance benefits of portal axles at a fraction of the usual cost.
A cheaper route to portal clearance
Portal axles place a gear reduction at each driven wheel, allowing axle shafts and other hardware to sit higher above the ground. That raises the vehicle and reduces the parts hanging below the frame, which is useful on rocky terrain. A typical set from companies such as 74Weld costs about $20,000; the unit on Gage's Jeep costs about one-fifth of that.
The assembly combines a Ford 9-inch axle housing, geared hubs from a Humvee, and Jesse Haines Fabrication HMMWV portal adapters. Two-gear portals like the Humvee's reverse the rotation of the input shaft. To correct that, Gage flipped the differential upside down so the driveline spins in the proper direction. A Yukon Gear and Axle third member is bolted to the flipped differential, effectively turning low-pinion parts into a budget high-pinion arrangement.
Rear-only packaging
The conversion is intended to add about six inches of clearance. It also retains full shock travel, which can be tricky with portal axles, and reduces stress on the differential itself. The result should be effectively bulletproof.
Gage installed the portal axle only at the rear. That layout is common in the remote-control rock-crawler scene. By keeping the front solid axle, he avoids the packaging constraints that can arise when adding portal axles to a vehicle that never had them from the factory. He also does not have to limit shock travel for those constraints, and the ride height does not rise to an extreme level. The approach is described as a best-of-both-worlds solution.
Custom parts and the result
This is not an off-the-shelf kit. Gage fabricated brackets and custom-tapped plates, and he used a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it has an integrated electric emergency brake solenoid, as well as for clearance reasons.
The finished XJ can drive over a five-gallon bucket while retaining several inches of spare clearance. That means the rear end should not get hung up on obstacles that the front can steer around. The build required substantial custom work, but it shows how a rear-only portal setup can add clearance without a full front-and-rear conversion.
