Screen printing is a standard step in solar cell metallization, but the mechanical pressure and thermal treatment it involves can degrade device performance. The issue is particularly relevant to copper-plated silicon heterojunction (HJT) solar cells, which are seen as a promising route to lowering metallization costs and reducing reliance on silver. Researchers in China have now tied the damage to wear of the printing screen itself and tested a modified screen design intended to limit it.
The work was published in the journal Solar Energy as “Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells.” According to corresponding author Lang Zhou, the photoresist printing step in HJT cells differs fundamentally from conventional silver paste printing. In silver paste printing, Zhou said, the screen openings cover only 2–5% of the total area, while the rest of the surface carries an emulsion layer that keeps the mesh from touching the wafer. Full-area photoresist coating usually relies on a screen without emulsion coverage so that resist is deposited evenly across the whole wafer, which means the mesh comes into direct and extensive contact with the wafer on every printing cycle.
Earlier production data cited by the researchers showed conversion efficiency slipping from 26.2% to 25.7% across 15,000 consecutive printing cycles in commercial solar cell manufacturing. The losses were attributed mainly to lower open-circuit voltage and fill factor, while short-circuit current density and electrical resistance stayed largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Using three-dimensional confocal microscopy, the team identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles flatten, their contact area with the wafer grows and mechanical stress on the underlying passivation layers increases. Scanning electron microscopy revealed no visible surface scratches, but photoluminescence measurements confirmed higher recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
Emulsion buffer layer
To block direct contact, the researchers added an emulsion buffer layer to the screen and evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%. The trials exposed a trade-off: greater coverage protected the wafer but disturbed photoresist distribution. A coverage ratio of 4.7% gave the best balance, holding minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while keeping coating uniformity relatively good. The team attributed the improvement to the emulsion layer separating mesh and wafer and thereby reducing cumulative mechanical damage to the passivation stack.
Zhou said the results showed that a relatively simple modification to screen design could substantially mitigate printing-induced degradation, offering a practical approach to improving the manufacturing reliability of copper-plated HJT cells.
Copper metallization context
The study comes as copper metallization attracts growing interest as a substitute for silver contacts in HJT cells. In April 2026, researchers at China’s Nankai University reported a silver-free HJT cell at 25.2% efficiency using plasma-induced interface engineering and copper electroplating, an approach that addressed adhesion, contact resistance and stability challenges at the ITO interface. Separately, scientists at Germany’s Forschungszentrum Jülich reached 23.08% efficiency with a fully copper-metallized HJT cell; the silver-free device showed a relatively small efficiency penalty compared with its silver-metallized counterpart, and cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95%. Those results underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance remain necessary.
